Hondata S300 System, Hondata S300 V3 - HA Motorsports Hamotorsports.com S300 V3 Software and USB Drivers Download: smanager software download 'The Hondata S300 is an add-in module to the factory OBD1 Honda Engine Computer (ECU) which vastly expands the capabilities of the factory ECU. Navigate the list of applications until you locate Hondata S300 Drivers or simply activate the Search feature and type in 'Hondata S300 Drivers'. If it is installed on your PC the Hondata S300 Drivers app will be found very quickly.

Chopin complete edition torrent flac the milk. The Hondata injector driver allows either the use of high or low impedance injectors without a resistor box either as injectors slaved to the ECU injector output or as staged injectors. Staged injection allows the use of primary and secondary injectors of different sizes. The primary injectors are always used, and may be stock or other injectors with a rapid opening time and good spray pattern., The secondary injectors activate based on driving conditions, and may be larger than the primary injectors.

The injector sizes and dead times for each set of injectors do not need to be the same. Eg stock 310cc injectors can be used until boost, at which point both 310cc and 1300cc injectors are used. It also is possible to use two independent fuel systems for each set of injectors. Eg the secondary injectors may use E85 or race gas.

Staged injection requires ECU outputs. Currently this is only supported by the s300 & KPro as almost all FlashPro ECUs do not have accessible outputs. I'm using low impedance injectors with a stock without any problems. You just can't see the problems. Low impedance injectors draw more current than high impedance injectors and will eventually overheat if the injector driver output does not limit the current. The main concern is that the ECU injector driver outputs will be damaged as they are not designed for the amount of current a low impedance injector draws.

Can I run more than one set of injectors from the Injector Driver? No, because the way the Injector Driver controls current through the injectors will result in poor injector performance. You need to use one injector driver per set of injectors.

Can I chain multiple injector drivers to control more than two sets of injectors? The activation input may be shared.